CS501-Advance Computer Architecture Final Term Solved Subjective Paper
What function is performed by the reset operation of a processor? What are the two types of reset operations?
Answer:
Reset operation is required to change the processor‘s state to a known, defined value. The two essential features of a reset instruction are clearing the control step counter and reloading the PC to a predefined value.
Reset operation is required to change the processor‘s state to a known, defined value. The two essential features of a reset instruction are clearing the control step counter and reloading the PC to a predefined value.
Hard ResetThe SRC performs a hard reset upon receiving a start (Strt) signal. This initializes the PC and the general registers.
Soft ResetThe SRC performs a soft reset upon receiving a reset (rst) signal. The soft reset results in initialization of PC only.
What do you know about Hard disk? A hard disk
drive (HDD; also hard drive, hard disk, or disk drive)[2] is a device
for storing and retrieving digital information, primarily computer data.
It consists of one or more rigid (hence "hard") rapidly rotating discs
(often referred to as platters), coated with magnetic material and with
magnetic heads arranged to write data to the surfaces and read it from
them.
Hard drives are classified as non-volatile, random access, digital,
magnetic, data storage devices. Introduced by IBM in 1956, hard disk
drives have decreased in cost and physical size over the years while
dramatically increasing in capacity and speed. Hard disk drives have
been the dominant device for secondary storage of data in general
purpose computers since the early 1960s.[3] They have maintained this
position because advances in their recording capacity, cost,
reliability, and speed have kept pace with the requirements for
secondary storage.[3]
(0.23) 10 convert in base 2?
What is meant by Packet switching?Ans lecture no 34 ….(page no360)
Classification of fiber optics mode multimode and mono mode?Solution
Multimode: this fiber has large diameter when light is injected, it is disperses, so the effective data rate is diereses.
Mono mode:its diameter is very small. So dispersion ios small and data rate is very high.
Multimode: this fiber has large diameter when light is injected, it is disperses, so the effective data rate is diereses.
Mono mode:its diameter is very small. So dispersion ios small and data rate is very high.
Considered a 64kb direct mapped catch with a line length of 32bytesa .determine the number of bits in the address that refer to the byte within a cache line.b.determine the number of bits in the address required to select the cache line.Solution (lecture no 41 ) page 348 o
If a DRAM has 512 rows and its fresh time is 9ms .What shoul be the frequency of row refresh operation on the average?Solution
Refresh time =9ms
Number of rows =512
Therefore we have to do 512 rows refresh operation in 9ms interval.in other words one row refresh operation every( 9*10-³)/512=1.76*10 second
Refresh time =9ms
Number of rows =512
Therefore we have to do 512 rows refresh operation in 9ms interval.in other words one row refresh operation every( 9*10-³)/512=1.76*10 second
Structural RTL for not instruction not ra ,rbSolution in lecture no 13
Why we use matrix in decoder?
